Kennedale Plumbers Who Fix It Right, Today

I thoroughly inspected and tested all electrical components, confirming they were functioning properly with good amperage draws. The refrigerant levels were verified to be adequate, and the temperature split was within acceptable parameters. Drains were clear, and the condenser was clean. The air filter was in good condition, and the evaporator coil was inspected, though it was found to be dirty. The blower wheel also required cleaning. I left detailed estimates for the necessary maintenance and cleaning tasks.

During the visit, I thoroughly inspected both sides of the system, noting that it operates with a 5-stage heating and 11-stage cooling process. I identified several issues, including a malfunctioning float switch that was out of the drain and an emergency pan filled with water. Despite these problems, the client expressed a preference to manage the repairs independently. I provided detailed explanations and guidance on the issues identified.

Upon arrival, I inspected the upstairs unit condenser and identified a faulty dual run capacitor as the root cause of its malfunction. After confirming the diagnosis, I replaced the defective capacitor with a new one. Following the replacement, the condenser functioned correctly, and the unit resumed proper operation. Additionally, I enrolled the customer in the Comfort Care Club for the upstairs unit, ensuring ongoing maintenance and support. Payment for the service and the monthly processing fee for the Comfort Care Club was collected via credit card, which will be used for future charges.

Upon inspection, the tankless water heater exhibited a persistent leak at the inlet, accompanied by a code 11 on the controller when in use. Despite the unit being 13 years old and out of warranty, I verified the incoming gas pressure and ignitors, which were functioning correctly. After unplugging and resetting the heater, it operated properly, but the issue recurred shortly. Given the age and history of the unit, I recommended replacing the tankless heater. I also provided a quote for replacing the water filter, noting that it had been replaced multiple times but continued to leak.

I successfully installed a new warranty evaporator coil unit, ensuring all connections were secure and tested for optimal performance. The system was thoroughly inspected to confirm proper functionality. The unit is now operating efficiently, providing enhanced cooling performance. All components were cleaned and inspected, and the system was tested for leaks and balanced for optimal airflow.

Upon arrival, I conducted a thorough evaluation of the indoor and outdoor units. The indoor unit was operational, while the outdoor unit had locked out and was overheating. Both units were heavily caked in mud, so I proceeded to clean them thoroughly. I washed the coils and reset the unit's code. After these steps, the unit started cooling effectively with no further issues. I also changed the filters to ensure optimal performance. During my visit, I highlighted the benefits of the Comfort Club, emphasizing its advantages. By the time I left, the system was cooling efficiently.

I replaced a failed outdoor capacitor, restoring proper cooling. The outdoor unit was cleaned to ensure optimal airflow and prevent overheating. I tested the system to confirm it was functioning correctly. Additionally, I recommended installing a start kit on the outdoor unit to reduce the compressor's amp draw. No further work was required at this time. The system is now cooling effectively.

I recently completed a comprehensive gas installation project for a customer. After a thorough assessment, I provided a detailed quote of 36k for the work required. The customer was keen on getting his bonus a week early to fund the project. We discussed various options, including level 4 and level 5 installations, to ensure the best fit for his needs. Throughout the process, I maintained open communication with the customer, pausing the job temporarily to allow him to finalize his bonus arrangements. Once the funding was secured, we resumed the project, ensuring all work was completed to the highest standards. The customer was very satisfied with the results, highlighting the importance of clear communication and flexibility in meeting client needs.

Upon inspection, it was discovered that the issue was not related to an outdoor TXV as initially thought. Instead, the unit was low on refrigerant, and a leak was found at the evaporator coil. The coil is under warranty, and all relevant information is documented in the parts section. The remaining balance will be collected upon job completion.

I conducted a thorough evaluation of both systems, finding issues with thermostat satisfaction. The downstairs system showed no temperature change, while the upstairs system had a 10-degree difference. I replaced the filters, ensured the drains were clear, and tightened electrical components within tolerance. Safety mechanisms were checked, and refrigerant levels were found to be low with signs of previous leak attempts. I diagnosed the need for coil replacement and refrigerant refill on both units, along with a metering device replacement for the downstairs unit. Scheduled a comfort advisor for Friday and an electrician for the garage outlet. Systems were operational when I departed.

Upon evaluation, the unit was operational but not meeting thermostat settings. The temperature difference (delta) was approximately 5 degrees, and the superheat was around 50. After thorough inspection, the issue was identified as a failed metering device and a clogged filter drier. The homeowner opted for the Home & Business plan, and I ordered the necessary replacement parts. I will return to complete the repair once the parts arrive.

I thoroughly inspected and serviced both electrical components, ensuring all amp draws were within acceptable limits. The freon levels were verified and topped off as needed. Temperature splits were optimal, and all drains were cleaned and clear. The condenser was meticulously cleaned, and the filter was replaced. Gas safety checks were conducted, and all equipment was confirmed to be functioning properly. Payment was collected via credit card.

I addressed a recurring issue with two interconnected drain lines that were frequently clogging. The customer had previously considered installing a ball valve to manage the problem, but the cost was too high. Instead, I thoroughly cleared both drain lines to ensure smooth operation. After the work, I tested the system to confirm that it was functioning correctly. The customer was satisfied with the solution, and the system was left running efficiently. Thank you for choosing our services.

Customer has to leave to go to a wedding reviewed many options they will be discussing to let me know could not finish the meeting customer had to leave

Emailed customer a quote for a level 3 60 k gas system.

What time do you job for electrical inspection and house is only 3 years old and everything looks really good has all GFCI and afci breakers as well as search protection and everything is in really good shape has disconnect on the outside and meter base that all look in really good shape still took it looked throughout the house had you five protection where it was needed every plug was working every light switch customer did want to put a fan up in the bedroom and swap it out so gave price to do that and did it while I was there in customer super happy with everything

Completed Stu all electrical components good amp draws good freon good Temp split good drains clean clear filter good all electrical heat working condenser clean system operating correctly went over options with customer

Quoted customer a 48k system with ductwork

On this job I discovered and the evap clogged up boliogrowth on the blower and wiring. After talking to home owner he wants system replacement with duct cleaning. Set for tomorrow 10am to 12.

Sold level 4 60k h/p

On this job I tested the system in heat and cooling. System did not test in tolerance. Sh 57 Sc 4.5 Blown out hard start Burnt contactor System is falling apart on the inside. He wants to talk system replacement tomorrow 2 pm

For this job, I worked on a double super tune-up on two heat pump systems. I went through all the mechanical and electrical components of the system and checked for maximum efficiency. Filters were replaced and outside condensers were washed. Adding on, UV bulbs were recommended to customer due to biological growth on both of his systems, picture was shown to customer. In addition, a micro airsoft start device was recommended for both units, I informed the customer about the benefits of this device, I explained the benefit of a soft start, low amperage, and longitivity. Customer will think about it and call the QR code that was given. Thank you for choosing Comfort experts, have a great day!

Install 12k mini split

Level 1 12k mini split

For this call I performed a evaluation. Homeowner wants a quote for a mini split unit installed in his office for heating and cooling. Main area heating conponant is a gas furnace. Unable to complete evaluation due to gas being completely disconnected. Shop owner is to get in contact with the city to see about getting the gas meter reinstalled. Shop owner would also like to go ahead and have a estimate of a new gas furnace replacement as well.