Arrived for a STU All components were working and in tolerance, besides the cap. Relayed Information to customer. Customer okayed for new cap. Recommended flame sensor, dual cap, and compressor saver. Installed cap and system was working before I left.

Arrived for STU Drains clear Installed IAQ1000 Complementary Blower clean Furnace components fine Coil clean Washed condenser coil Capacitors, motors and refrigerant are fine

Replace wire from box to indoor unit and braker and new Canduit to box on outside of home

Cust has to have hour and half notice that mark w and Brian H are headed this way

Arrived for service eval Drain line backed and drain switch tripped Cleared drain line and system running Capacitor fine Filter fine Amp draws fine Refrigerant fine

Upon arrival for service system on and cooling. Customer states system making metallic rattling noise on start up. Inspected system. Found copper line pressing against metal line cover causing ratting. Adjusted system placement on pad and rattling stopped. Left system on and cooling without rattling noise.

2019 system straight cool with gas furnace in good clean condition after condensor cleaning system is ready for cooling. Filters are new too. Thanks for choosing comfort experts.

Per Joe added 9" cut in to master bed room and re routed two 8" ducts going to the den from being straight runs to a 10-8-8

Rearranged ductwork at the plenum. This is a callback on Travis/Jhorden.

Arrived to find that the run of duct supplying the master bedroom ,bathroom and bedroom 3 will need to be re worked called Joe he and another installer will be coming out to fix it tomorrow morning customer needs it done before noon

Install gas 48k horizontal with standard filtration, new duct system, disconnect, whip, drain pan

HTU performed today, ignition components are working properly, heat exchanger looks good, inducer motor is only pulling .3 amps and it should be pulling .7 let customer know that this is an indication of a failing motor, customer spoke with comfort advisor earlier this year and plans to replace system in March, i let him know about the changes that are occurring at the end of this year and how the prices are going to go up and availability won’t be very good, customer is going to call Danny and talk to him, did not want to schedule to have him back out

HTU performed today, ignition components are working properly, heat exchanger looks good, inducer motor is only pulling .3 amps and it should be pulling .7 let customer know that this is an indication of a failing motor, customer spoke with comfort advisor earlier this year and plans to replace system in March, i let him know about the changes that are occurring at the end of this year and how the prices are going to go up and availability won’t be very good, customer is going to call Danny and talk to him, did not want to schedule to have him back out

HTU performed today, ignition components are working properly, heat exchanger looks good, inducer motor is only pulling .3 amps and it should be pulling .7 let customer know that this is an indication of a failing motor, customer spoke with comfort advisor earlier this year and plans to replace system in March, i let him know about the changes that are occurring at the end of this year and how the prices are going to go up and availability won’t be very good, customer is going to call Danny and talk to him, did not want to schedule to have him back out

HTU performed today, ignition components are working properly, heat exchanger looks good, inducer motor is only pulling .3 amps and it should be pulling .7 let customer know that this is an indication of a failing motor, customer spoke with comfort advisor earlier this year and plans to replace system in March, i let him know about the changes that are occurring at the end of this year and how the prices are going to go up and availability won’t be very good, customer is going to call Danny and talk to him, did not want to schedule to have him back out

Upon arrival for tune up system on and cooling. Inspected outdoor unit. Cleaned outdoor unit. Capacitor within tolerance. fan and compressor amp draw within unit specifications. Refrigerant pressure good. Inspected indoor unit. Drain line clear. Blower and coil clean. Electrical heat functioning.