HVAC, Plumbing, & Electrical Services in River Oaks, TX

For this job I did a super tune up. Changed filter. 13YO Rheem Gas furnace: -3 ducts are damaged and need to be repaired/replaced. -all the ducts are incorrectly installed at the plenum. Return side is pulling attic air in causing huge inefficiencies. -Gas line is not up to code and furnace door cannot be attached properly. -Drain pan has standing water -No water safety anywhere -reseal plenum due to airloss to attic. Ducane: Drain tested clear. Electrical components tightened and in tolerance. Delta is good. Outdoors, refrigerant is fine. Electrical components testing in tolerance. Recommend whole home surge protection. Homeowners would like to sell home before end of the year. Due to growing # of concerns and age of system. I believe it would be in their best interest to speak with a Comfort Advisor about replacement options. Homeowner would like to get in touch with home warranty before making any decisions. System cooling when I left.

For this job I did a super tune up. Changed filter. Drain tested clear. Furnace components are good. Deltas are good. Tightened electrical connections. Recommend IAQ 300 Oxidizing & Germicidal UV system for allergy/odor relief. Outdoors, refrigerant is good. Electrical components are in tolerance. Washed coil. Compressor rated for 109 starting amps, currently 118. Recommend start kit to address over amping and extend compressor life. Recommend surge protection. Went over benefits of updating to H&B. Homeowner declined work for today System in auto when I left. Thank you for choosing Comfort Experts

Rec work- replaced fail TxV Pulled vacuum down to 324 microns Per Ryan- not to charge refrigerant since this was a pump down only method to recover refrigerant I did not need to adjust pressures System was operational afterwards with a 22 degree delta Thank you for choosing Comfort Experts, have a great day

I'm pausing this job until she can get financing.

Came out for a membership plumbing inspection at the door homeowner informed me that she had all of her Plumbing replaced in 2005 and she has a personal plumber that comes out regularly and fixes anything that she has an issue with she also has an electrician and her only desire from us is to uphold the warranty on her HVAC system no inspection was made and therefore no recommendations

Performed home inspection customer is selling home as is but gave her estimates for water heater and repipe has all galvanized lines and low water pressure to fixtures

Came to job for electrical inspection and ended up finding out that panel is a Challenger panel and that we have done a little bit of work on it but does not have a main breaker or a disconnect so not too sure if that will be an issue when they go to sell this house or not but informed them on if it was going to be an issue that this is what we would need to fix and gave them a quote for that

Completed cooling tune up all electrical components good amp draws good Freon levels good temperature split good cleaned condenser changed filter drains clean and clear system operating correctly

On this job I looked at both heating and cooling sides of the system. Cooling makes a 10 subcool td is 20°. The system in heating goes thru order of operation just as it should. The system is now washed and filter is clean.

Credit declined

For this job I provided the customer with 2 separate options for repairs.

Performed evaluation Upon arrival indoor unit operational Outdoor unit compressor not operational – Fan turns on Capacitor reading 4.6MFD Replaced capacitor and system is cooling and operational System left on cool at exit

Replaced filter – filter had large amounts of build up Reccomended duct cleaning No system issues from homeowner System left on cool at exit

Found unit super low on r22 Freon only running at 40 psi leaking evaporator coil got customers set up with advisor Monday between 9:00 and 12:00

Arrived onsite customer had a broken toilet in hall bathroom That was broken. Went ahead and installed customer supplied toilet in hall bathroom. Tested after install everything working properly.

Technician arrived to home, handed home questioner and started in furnace on attic. Technician changed filter, blower wheel looked clean, plenums in good condition, insulation level r30, drain lines have slight buildup mentioned to homeowner, electrical readings in range aswell as wires in good condition. Technician moved to condenser unit, washed coils in and out and waxed units shell. Refrigerant levels In range, capacitor in range, unit did have a compressor saver, contactor in good condition. Overall system cooling and heating efficiently.

Performed super tune up Washed condensors and tightened connections Filters were recently replaced Deltas 17-20 All cooling and heating components are in tolerance Reccomended condensor blower replacement – photo of information in miscellaneous Reccomended blower clean Reccomended drain saftey switch Reccomended soft start kits Reccomended drain clear – slow-medium water Reccomended comfort advisor Systems left on cool at exit

Arrived for service eval on mini splits Quoted re running drain lines Adding water safeties to each indoor unit Lifting and mounting condensers to the wall Trimming line sets and wires to size and recovering with lineset cover Homeowner will discuss with her husband and get back to us

Electrical to AC Need a HVAC-Tech to go out on Monday and check the mini splits that were installed by a different company to see if maybe we can improve their drainage situation and possibly offer alternatives

On this job I inpected the system for tolerance. I retrimed out the return box to make it easier to access the filter base. The system is putting out 140° air in heating. Intake is 88. The system could use an easy start out side to help inrush Amps. Other then this the system test in tolerance.

Htu completed, while inspecting system I found the induced motor running at max rated amps and it was making a loud high pitch noise Recommended replacement, cst needs to wait a couple of months before completing repairs, cst signed up for membership need to follow up

Tech Cody arrived to customer's home and met the homeowner. System is a 6yo Goodman furnace. INDOOR: I replaced the filter, the blower is clean, the blower motor is in good condition, the blower capacitor is within tolerance, and the coil is clean. The furnace went through all of its safeties with no issue and began to operate normally. The system had a UV light installed and it was functioning properly, and the system had a 18 degree temperature split. OUTDOOR: I washed and waxed the unit before taking any readings. The compressor and fan motor were operating within manufacturer range, the unit had a compressor saver installed, the capacitors were within tolerance, and the primary electrical control was in good. The refrigerant charge was within acceptable levels at this time. I shared my findings with the homeowner and left the system off at the thermostat per the request of the customer as I left.

2023 Ducane Airhandler Checked and tightened all electrical connections Customer recently changed filter Drain was clear and draining Heat strips were functional and within manufacture range Blower motor and wheel were acceptable Evaporator coil has biological growth build up 2023 Ducane Straight electric Checked and tightened all electrical connections Dual run capacitor was within manufacture range Primary electrical unit was acceptable Refrigerant levels were acceptable at this time Fan blades and motor were acceptable Condenser coil was acceptable Washed Condenser coil from inside out Cleared debris out of unit Waxed top of unit Recommended uv system for biological growth inside system, Customer wanted to call the office and talk about uv systems

Customer has an old water heater that should be updated and also need to pull and reset toilet in hall bathroom. Made recommendation to address items customer will call us when she wants to do something not ready for anything at the moment.

2018 2t goodman gas. System down upon arrival. Diagnosis discovered- 45/5 dual run capacitor on condenser unit was bloated (open) – replaced. Utilized manufacturers warranty on part. Had to use a seperate 45 and 5. System functioning.