Weatherford TX - Local HVAC, Plumbing & Electrician Services

Heating tune up performed today on a Fridgidaire electric furnace with a straight cool nordyne condenser installed in 2003. R-22 system. Blower wheel and evaporator coil are dirty. Heat strips are pulling proper amperage. Customer has purchased a level 1 duct cleaning to be completed on Thursday morning.

Came to job customer wasn't there

Water softener

Did job. Everything good.

Super tune performed today on a Trane heat pump with air handler installed in 2016. All electrical connections are tight with no corrosion. Heat strips are pulling proper amperage. Ecm blower motor is acceptable. Air handler is clean. Compressor and condenser fan motor are acceptable. Reversing valve and defrost control board are working properly. Refrigerant levels are in range. Highly suggest adding surge protection to ensure the system is not damaged in the event of a power surge.

Super tune up performed today on a two year old Goodman heat pump and air handler. All electrical connections are tight with no corrosion. Heat strips are pulling proper amperage. X-13 blower motor is acceptable. Blower wheel and evaporator coil are clean. Compressor and condenser fan motor are acceptable. Refrigerant levels are in range. Reversing valve and defrost control board are working properly. Outdoor unit was washed and waxed. Installed a new UV bulb and a compressor saver on this visit to help with air quality and the reliability of the system upon startup.

Heating tune up performed on two system home. Both units are carrier heat pumps with air handlers installed in 2022. All electrical connections are tight with no corrosion. Ecm blower motors are acceptable. Inside of air handlers are clean. Heat strips are in range. Both systems reversing valves and defrost control boards are working as they should. Attic insulation is low in many spots. Refrigerant levels appear to be low on both systems however both systems are at the same level meaning that may how they were installed. Highly suggest adding attic insulation, a compressor saver on each outdoor unit and a UV system to improve air quality in the home.

Super tune up performed today on a Coleman gas furnace with a straight cool condenser installed in 2017. All electric all connections are tight with no corrosion. Gas valve, inducer motor, burners and ignition are all working as they should. Ecm blower motor is acceptable. Heat exchanger is acceptable. Blower motor and evaporator coil are clean. Compressor and condenser fan motor are acceptable. Condenser fan motor is loud but there is no movement in bearings and amp draws are in range. Outdoor unit was washed and waxed.

Completed super tune up Checked and tightened all electrical connections Filters were acceptable Drain has some build up in trap Heat strips were functional and within manufacture range Blower motor and wheel have biological growth build up Blower wires have biological growth build up Evaporator coil has biological growth build up Checked and tightened all electrical connections Dual run capacitor was within manufacture range Primary electrical unit was acceptable Refrigerant levels were acceptable at this time Fan blades and motor were acceptable Condenser coil was acceptable Washed Condenser coil from inside out Cleared debris out of unit Waxed top of unit Recommended uv system for biological growth, drain safety, pan treatment and compressor saver. Customer agreed to have all work done, paid full total and rec work needs to be scheduled for 11/22/24 9:00 AM first call

2015 Goodman dual fuel furnace Checked and tightened all electrical connections Changed Customer provided filter Drain has some build up in trap Ignition system is functional All safeties are functional Blower motor and wheel were acceptable Evaporator coil was acceptable 2015 Goodman heat pump Checked and tightened all electrical connections Dual run capacitor was within manufacture range Primary electrical unit was acceptable Refrigerant levels were acceptable at this time Fan blades and motor were acceptable Condenser coil was acceptable Washed Condenser coil from inside out Cleared debris out of unit Waxed top of unit Recommended pan treatment agreed to install pan treatment

11/14/24 Upon arrival the outdoor system was in a lockout After resetting at starting back up I got the PO code - compressor protector open Replaced compressor saver and fixed loose connections Due to cold temps outside I need to return during the day next week for quality check. System is on and operating at this time Setting up for me to return next week

Upon arrival technician was shown to the condenser, thermostat and the air handler tech asked the home owner a couple of questions about his unit and when the breaker would go off as well as when did it start happening. Tech started with the outside unit tech found that the Tsat wire did have some exposed wires. Tech also found that the 240 wire coming out the wall was showing exposed wires tech tried to get the unit to trip. Tech took apart the unit where tech cleaned and washed the unit. Technician waxed the unit and got all his readings. The refrigerant levels didn’t look the best technician believes it was due to the rain. Tech had gotten a good delta split in temperature. Tech headed to the attic where tech connected to the unit and looked for a code history and found that the unit didn’t have a code. Tech took out the filter where it was really dirty homeowner didn’t have another filter. Tech put the filter back in explaining to homeowner that there needs to be a new one in as so

2015 Amana airhandler Checked and tightened all electrical connections Changed Customer provided filter Heat strips were functional and within manufacture range Drain had some build up in trap Blower motor and wheel were acceptable Evaporator coil was acceptable 2015 Amana heatpump Checked and tightened all electrical connections Dual run capacitor was within manufacture range Primary electrical unit was acceptable Refrigerant levels were acceptable at this time Fan blades and motor were acceptable Condenser coil was acceptable Washed Condenser coil from inside out Cleared debris out of unit Waxed top of unit Recommended pan treatment, agreed to install pan treatment

Came to house for tune up and checked panel and GFI protection on the outside of the house and the inside plugs and checked power at panell

Inspected cst duct work due to high dust levels in the home When inspecting the duct work I found biological growth throughout. Cleaning the duct work is necessary but is not a permanent solution so I recommend installation of air scrubber after duct cleaning is complete Duct cleaning scheduled when is completed we can schedule installation of IAQ

Tech Cody arrived to customer's home and met the homeowner. Right side: INDOOR: System had a temperature split of 21 degrees, the filter was clean, the coil was clean, a UV system was installed and operating normally, the blower was clean, the blower motor was in good condition. Heat strips were in range. OUTDOOR: I washed the coil, the compressor and fan motor were operating within manufacturer range, the auxiliary motor starter was within tolerance, the primary electrical control was in good condition. Refrigerant charge was at acceptable levels at this time. Left Side: INDOOR: System had a temperature split of 21 degrees, the filter was clean, the coil was clean, a UV system was installed and operating normally, the blower was clean, the blower motor was in good condition. Heat strips were in range.OUTDOOR: I washed the coil, the compressor and fan motor were operating within manufacturer range, the auxiliary motor starter was within tolerance, the primary electrical control was in

Performed heating tune up on both systems Check and tightened all electrical connections Changed Customer provided filter Drains had some build up in traps Customer Cleared drains himself Heat strips were functional and within manufacture range Blower motor and wheel were acceptable Evaporator coil was acceptable Heatpumps Checked and tightened all electrical connections Dual run capacitorswas within manufacture range Refrigerant levels were acceptable at this time Primary electrical units were acceptable Fan blades and motor were acceptable Condenser coil was acceptable Washed Condenser coil from inside out Cleared debris out of unit Waxed top of unit Recommended pan treatment

Upon arrival technician talked to homeowner. Tech started with the condensers. Tech found that one unit had a compressor saver and the other didn’t. Technician cleaned and washed the units tech also waxed the units. Tech started getting his readings starting with inrush as well and running amps. Tech headed to the attic where tech found that the unit the uv light in the big system was out. There was biological growth on the blower wheel tech suggested cleaning it and well as clean out the primary drain. Technician showed the homeowner the difference in the unit that has a uv light that is working and the uv light that is out. The little unit is clean and didn’t need a cleaning. Homeowner agreed to do the cleanings. Homeowner didn’t have filters and said they will change it out next week when they go up there.

We will open sheetrock in son's room at front hose bibb and repair copper line. No warranty on existing copper. Customer is responsible for drywall repair Customer had to leave to pick up daughter. Paid in full closed up house when finished

Performed coil cleanings, blower cleaning and replaced flue to attic

Emailed estimates for multiple projects.

2003 4t gas closet upflow. 1inch Filter not replaced regularly. Blower wheel has heavy buildup which reduces optimal airflow. Blower motor has heavy buildup and oil marks indicating compromised bearings. Entry to burner flames have heavy rust. Flame displacement on burners indicate end of life of heat exchanger, an extreme health hazard. A bolt has been installed improperly from the indoor unit cover to the flue pipe, an extreme health hazard. Flue pipe does not have proper clearance going into the attic, a thermal picture indicates over 100° is touching the ceiling drywall. Gas flex line going into the service area is against current code. The evaporator coil has visual indications of a refrigerant leak (oil spots) and rust, performed a courtesy leak detection and detected refrigerant molecules leaking out, health hazard. Evaporator coil was below freezing and homeowner confirmed a history of freezing evaporator coils. Supply plenum has heavy biological growth, a health hazard. Com