HVAC, Plumbing, & Electrical Services in Mansfield, TX

Upon receiving the call about a malfunctioning system, I inspected the equipment and identified a failed capacitor that had exploded internally. The customer chose to replace the capacitor only, despite my recommendation to install a Compressor Saver for added protection and longevity. After replacing the capacitor, the condenser fan motor did not start. I allowed the system to cool, and upon retrying, the motor began running. The motor had overheated due to the faulty capacitor. I tested the motor to ensure it was not defective. The system was functioning correctly and cooling efficiently when I left. Thank you for choosing our services.

Upon arrival, I conducted a thorough inspection of the systems in place. After evaluating the functionality, I confirmed that everything was operating as intended. The customer expressed satisfaction with the current state of the systems but was uncertain about the reason for my scheduled visit. Despite my offer to provide an estimate for future services, the customer declined, emphasizing that they would contact us if any issues arise in the future. I ensured that all systems were in optimal working condition before concluding the visit.

Upon arrival, I identified that the cooling system was not functioning correctly. After a thorough inspection, I discovered the thermostat had been reset to its factory default setting of 78°F due to a recent power outage. I explained the situation to the customer and adjusted the thermostat to maintain a consistent 75°F for cooling and 68°F for heating throughout the week. The system began to operate as intended, and no additional issues were detected. Thank you for choosing our services.

On September 17, I conducted a thorough inspection of the water heater, ensuring all safety and operational aspects were in optimal condition. The inspection included checking the temperature settings, examining the anode rod for corrosion, and verifying the pressure relief valve function. Additionally, I inspected the insulation and connections for any signs of wear or damage. The water heater passed the inspection, indicating it is functioning correctly and safely. However, the job was temporarily paused to allow for a tunneling project inspection, which required immediate attention.

Service Call Summary I responded to a call for three gas furnace cooling turnups. Starting with the outdoor units, I cleaned the condenser coils, checked the refrigerant charge, and changed the filters. After inspecting the electrical components, I identified one unit with high amperage and recommended a soft start, which the customer agreed to install. I also suggested a compressor saver for the older unit, though the customer opted out for now. Moving to the indoor units, I verified temperature splits and internal component operation, and ensured proper drainage by pouring water into the primary drain lines. The customer's upstairs system was not cooling below 78°F, but after replacing the filter and cleaning the unit, it reached 75°F, showing improved performance. All systems were cooling properly at departure.

Upon evaluation, the homeowner reported that the thermostat temperature had been gradually rising above the setpoint over the past month. After a thorough system inspection, I found the condenser coil and air filter to be dirty. I replaced the air filter and cleaned the outdoor coils. The refrigerant levels were fine, and the delta T was at 20°. Additionally, the UV bulb in the indoor unit had failed, so I replaced it. The system now operates correctly, providing proper cooling and airflow.

During the evaluation, I identified a clog in the primary drain line. This issue was causing significant drainage problems. I recommended a membership for future discounts and offered to unclog the drain immediately. Although the homeowner declined the membership, I proceeded with the unclogging. The clog was successfully removed, restoring proper drainage. Thank you for choosing our services. We appreciate your trust in our expertise. Have a great day!

Upon arrival, I conducted a thorough inspection of the electrical system and identified a malfunctioning switch. The switch was not responding to user input, posing a potential safety hazard. After careful examination, I determined that the switch unit needed to be bypassed to restore proper functionality. I successfully bypassed the faulty switch and tested the system to ensure everything was working correctly. The bypassed switch unit operated as intended, and I provided the customer with a detailed explanation of the issue and the solution. Payment was collected via credit card, and I ensured the customer understood the work performed and the importance of regular electrical system checks.

I performed a comprehensive inspection and maintenance of the HVAC system. All electrical components were thoroughly checked and found to be functioning correctly. The amperage draws were within acceptable limits, and the freon levels were balanced. The temperature split between the indoor and outdoor units was optimal, and the condensate drains were clean and clear. The condenser coils were free of debris, and the filter was replaced. Additionally, the heating elements were tested and operated properly, ensuring the unit was fully functional.

During the service, I inspected both the R22 and 410A cooling systems. The R22 system was found to be overcharged, causing the compressor to ingest liquid instead of vapor, which can severely damage the compressor. The 410A system was slightly undercharged, with a superheat of 4.8, whereas it should be between 8 and 10. Both systems were thoroughly cleaned. The next steps involve recovering the R22 refrigerant and adding 410A refrigerant to the appropriate system. Additionally, a soft start will be installed on the 410A system to enhance its efficiency and longevity.

I performed a Super Tune-Up on two gas furnace systems. I inspected the outdoor units, checked refrigerant pressures, and found one system out of tolerance. I recommended replacing the leaking evaporator coil and recharging the system, but the customer opted to address it later. I also suggested compressor savers for both systems due to elevated amperage. I cleaned the coils, inspected electrical components, and ensured proper drainage. Both systems had a good temperature split and were cooling effectively, though one was less efficient due to the refrigerant leak.

Upon arrival, I identified a clogged drain line. After discussing with the manager, I applied a discounted service fee. The system was heavily clogged with slime, sludge, and biological growth. I removed the obstructions and restored full functionality. I informed the homeowner about the extensive biological buildup. To prevent future issues, I poured bleach through the drain line. The system is now operating correctly, ensuring optimal performance. Thank you for choosing our services.

I successfully restored the customer's system to full operational status. Upon inspection, I meticulously checked the refrigerant pressures and performed a thorough cleaning of the outdoor unit. This maintenance helped ensure optimal performance and efficiency. During the cleaning process, I identified a 20° temperature split, which is within acceptable parameters. Additionally, I noted the presence of biological growth inside the system. I informed the customer about this issue and advised them to address it during our next visit. This proactive approach ensures the system's longevity and continued efficiency.

I conducted a comprehensive virtual inspection of the system, meticulously examining each component to ensure optimal performance. Utilizing advanced diagnostic tools, I assessed the system's functionality, identifying and resolving any potential issues. Throughout the inspection, I maintained clear communication with the client, providing detailed explanations of the findings and the steps taken to ensure the system's efficiency. The system was thoroughly tested under various conditions to confirm its reliability. Ultimately, the system passed the inspection with flying colors, demonstrating its robust performance and readiness for continued use.

Upon receiving the call, I promptly assessed the issue with the high voltage system. The initial inspection revealed a burnt loose wire, which posed a potential safety hazard. Following safety protocols, I carefully stripped back the damaged section to expose the good bare copper. With precision, I rewired the connections, ensuring they were secure and properly insulated. After completing the repair, I tested the system to confirm that it was functioning correctly. The system came back on without any issues, and the customer was satisfied with the resolution. Thank you for choosing our services; we strive to provide reliable and efficient solutions. Have a great day.

Upon arrival, I inspected the exterior plugs that were not functioning. After a thorough examination, I identified a tripped Time-Frame Current Interrupter (TFCI). After resetting it, all the plugs began working again. I explained to the customer that if any issues arise or if they notice anything unusual, they should contact us. Additionally, I discussed the possibility of replacing the existing uplights with newer models. I provided a quote for this service, including the lights and boxes, and encouraged them to reach out when they are ready to proceed.

I contacted Mr. Anderson to discuss his plumbing needs. He mentioned that he hadn't received a quote yet but was informed of our pricing over the phone. He expressed that the amount seemed high. I advised him to obtain a quote from another service provider and compare it with ours. Once he has the other quote, I will review the pricing with him to see if we can offer a competitive solution. Currently, he is awaiting the other quote, so we have paused the work until I can speak with him again tomorrow.

We are planning to schedule work for Tuesday morning of next week. This task requires an additional set of hands to ensure timely completion. Additionally, we need to obtain the necessary permit for the job. If possible, please assign Carl or Zack for this work. The job involves detailed tasks that will require careful attention and expertise to ensure everything is done correctly and efficiently.

Today, I thoroughly inspected both HVAC systems. The downstairs unit was particularly noticeable due to its low superheat, indicating a potential issue. Upon further examination, it was determined that the system could benefit from a refill of 410a refrigerant to restore optimal performance. I conducted a detailed analysis of the system's refrigerant levels and identified the need for the refill. This process ensures the system operates efficiently and maintains the desired cooling effect. The upstairs system was also reviewed, but no immediate issues were found.

We provided a quote to a customer for a thermostat replacement. The customer decided to consult another company to verify the issue before proceeding. He plans to have the original installation company replace the thermostat, as it is still under warranty. During our initial assessment, we thoroughly examined the existing thermostat and identified the need for a replacement. We ensured the customer understood the potential costs and benefits of proceeding with our quote versus relying on the warranty service. Our team remains available should the customer need further assistance or decide to move forward with our services.

the safety switch was linked to the common terminal on the board. I safely disconnected the safety switch, restarted the system, and successfully controlled it via the thermostat. The system functioned correctly, and I left it running. Additionally, I identified a minor refrigerant leak in the indoor copper line, which I informed the customer about, advising them to contact the previous company regarding the warranty.

Upon arrival, I identified that the outdoor condenser coil was heavily soiled, leading to high head pressure and excessive electricity usage by the compressor. This strain caused the capacitor to fail. After recommending and installing a new capacitor, I ensured the system was functioning correctly. I also discovered an obstructed drain system and a dirty air filter, both contributing to abnormal pressures. I cleared the drain by pouring 42 gallons of water, ensuring proper flow. I advised the customer to replace the air filter and turn off the system until done. The system was cooling effectively post-repair, but the customer requested it be turned off before leaving. Thank you for choosing our services.

I visited the customer to assess their needs and provided a comprehensive evaluation of the required services. I meticulously explained the proposed solutions, ensuring the customer understood each step of the process. I presented a detailed quote, including all potential costs and timelines. The customer appreciated the thoroughness of the information provided and requested more time to consider the options. I assured them that I would be available for any further questions or clarifications. I left with the understanding that a decision would be made by Thursday.

On August 17, I arrived to assess the HVAC system, which was struggling to maintain the desired temperature and was low on refrigerant. Upon inspection, I identified a leak within the evaporator coil, which necessitated its replacement. I paused the service to discuss the issue with the customer, who opted to utilize their warranty for the repair. I informed them that I would return once the replacement evaporator coil was available. On August 18, I reached out to schedule a follow-up visit. However, it was discovered that the current homeowners were not the original owners, and the warranty had not transferred. Consequently, I canceled the previously recorded work and scheduled a Comfort Advisor visit to assist with the next steps. Thank you for choosing our services. Have a great day.

During the evaluation, I thoroughly assessed the homeowners' duct system, which had previously been deemed in need of replacement by another HVAC company. Upon inspection, I identified severe air leakage under the trailer home. It's important to note that financing for duct replacement is not available for mobile homes inside of trailer homes. I informed the homeowners that replacing the duct system would likely cost around $10,000, give or take. While they appreciated the detailed assessment, they decided not to commit to a quote from a Certified Air Specialist at this time. Thank you for choosing our expert services; I hope you have a great day.