HVAC, Plumbing, & Electrical Services in Keller, TX

Low voltage missing from condenser Reset system and it turned on fine Tightened down all low voltage connections Sp waived service fee and system running fine at exit

Customer only wanted a coal replaced in a over 10 unit.

I have completed my search for the electrical problem and found that somewhere along the main neutral, it is either loose or disconnected as anything with a motor is shaking the electrical balance on the house, inside the panel connections are tight so most likely the problem is within the service side of their electricity, I did note that the meter it's self is very old so that's a really good first place to look

On this job I looked at both heating and cooling sides of the system. I'm happy to report that both sides test in tolerance. TD is 20. Subcool is 7 super heat is 16 Only concerned with fan motor heat and discoloration And inrush amps on compressor.

Came to house for doorbell wires messed up and wires were not messed up at all just that the doorbell is bad and needs to be replaced it works and rings without the doorbell but as soon as we put it on it just won't ring talk to customer about us replacing it for him but customer said he's going to do it himself

During this visit I looked at both system in heating and cooling. I'm happy to report that both system in heat and cooling test in tolerance. Both system are now washed and filters are now cleaned. TD is 20° Heating TD 30° Both system are up to code.

Service eval Contactor no longer passing high voltage into condenser Replaced Reinsulated damaged low voltage wire inside furnace System cooling at exit

On this job I looked at the heating side of the system.im happy to report it tested in tolerance. The line temp is 100° above ambient. I did notice the supply grills in multiple areas are dirty and could use a level 1 cleaning

Service evaluation Downstairs Front office is not getting to Temp like the rest of the downstairs System delta and refrigerant are fine No detectable damage to the duct in the ceiling Went over options. Best guaranteed fix will be a mini split Homeowner will consider and get back to us with here decision

During this visit I looked at 2 system on both heating and cooling side. I'm happy to report the systems both test in tolerance. I change 2 caps size 45:5. Both system condensor are washed and clean and filter are clean as well. TD is 20° Subcool 10° Superheat 15° Insulation 30

Customer just wanted estimate for customer supplied water filter under sink installation

On arrival system running and cooling. Customer complained of a musty smell. Found return duct strap broken off and return duct allowing musty attic air into system. Resealed and strapped duct with customers permission.

Today we return for recommended work. On our previous visit the homeowner wanted the condensation drain hard piped in instead of the flexible pipe. We had to order a fitting, once it arrived we called the homeowner and set up the schedule to return. We ran the condensation drain, tested and everything was working well when we left. There are no leaks. Thank you for choosing comfort experts!

Came out on a complimentary visit to look at water heater. Water heater is 10yrs old and out of warranty. Explained that home owners insurance will not cover damage caused by 10yr and older water heaters. Customer stated that she did not believe water heater needed to be replaced

On arrival both systems were not running due to a drain line clog. Customer cleared his own drain line while I checked refridgerant on his downstairs system. Added a pound and a half of 410 a to the downstairs system with the customers permission bringing the superheat down from 24 to 3. Both systems running and cooling as I left.

Today we set up for a complimentary plumbing estimate. Up on arrival the trouble with her AC backing up p-trap in the upstairs bathroom. The fittings that were used previously had rusted out and the drain piece actually broke away. He would have to give a brass condensation tee, and rerun condensation line. He would also replace the supply lines and add quarter turn shut offs underneath as well. We have to order this part, we will contact the homeowners once the part arrives and schedule for the install. Thank you for choosing Comfort experts!

On this job I insulated 2 p traps. The system current make a 20° td.

Emailed estimate for multiple projects. Offered membership. Service fee waived with competitors estimate. Customer has a couple other estimates scheduled. Scan.

Today I showed up for an evaluation on a 13-year-old system that was not running upon arrival I found a blown capacitor busted contactor and high pressure switch tripped discussed options with the homeowner and he has chosen to sit down with a comfort advisor to discuss full replacement thank you for choosing comfort experts!

Performed evaluation Washed condensor and tightened connections Delta 14 Reccomended primary electrical control unit Reccomended dual run capacitor Reccomended soft start Reccomended Schrader valves high/low Reccomended refrigerant Reccomended condensor motor Homeowner has had previous issues with condensor motor – currently operational System install reccomendations – return/supply – duct cleaning – unit does not have 4 inch base – April Air kit – IAQ200 UV – unit is inside attic – attic does not have ladder – homeowner is aware one is needed – in order to install unit Ceiling will need to be cut through; due to limited space Comfort Advisor scheduled Thursday 07/31/25 9am-12pm

Returned for evaluation Upon arrival system was operational and cooling Same specs of system were checked and compared System has low Delta 14 System is low on refrigerant Capacitor Reading 17MFD Homeowner denied repairs – still wants to continue comfort advisor for scheduled date

Arrived for service eval Bathroom sink overflowed Plumber on site to handle the issue Quoted running drain line to vent stack before leaving

Arrived onsite the drain for lavatory backed up causing a sudden loss of water. Went ahead and ran hand auger through drain and cleared stoppage. Everything working properly.

2004 Bryant Gas Furnace Checked and tightened all electrical connections Customer recently changed filters Drain was clear and draining Blower motor and wheel have heavy dust build up Evaporator coil was acceptable 2011 Amana Straight Cool Checked and tightened all electrical connections Dual run cap is extremely weak 45/5 testing 15/1 Primary electrical unit was acceptable Refrigerant levels were acceptable at this time Fan blades and motor were acceptable Condenser coils were acceptable Cleared debris from the bottom of the unit Washed condenser coils from inside out Waxed the top of the unit Recommended dual run cap replacement, compressor saver for hard starts, blower wheel cleaning and UV system Signed up for HBPPLAN installed auxiliary motor starter, compressor saver and cleaned blower wheel

Performed second opinion Evaluated system Delta 18 Indoor coil has significant wear and age Indoor blower motor has loose rod/bearings – blower capacitor is also out of tolerance Reccomended OEM indoor motor Outdoor condensor LRA 120 over standard 104 specification Reccomended soft start Primary electrical control unit has high wear on contacts Reccomended replacement Reccomended minimum insulation or better estimates insulation Reccomended drain saftey switch Reccomended home and budget protection plan System left on cool at exit Due to age and performance – system has minimum acceptable performance R22 system – major components have high wear Main reccomendation of comfort advisor is advised Scheduled Comfort Advisor Monday 07/14/25 12PM-4PM