AC Repair & Installation In Corinth, TX

On arrival systems running and heating as intended. Indoor units very clean and dust free, one of the supply plenums is beginning to build biological growth. I recommended a uv system to address this. The outdoor units passed all electrical testing but two overamped on start up. I recommended a compressor saver kit to address this. When I left system was running and cooling.

Customer had water coming from underneath toilet in downstairs bathroom. Pulled toilet and found the flange was broken. Went ahead and replaced toilet flange also reset and resealed toilet. Tested after repairs were made everything working properly.

We found that his pool pump was a significant pull on power definitely given the run times

Arrived for heating tune up Deltas are good All heating components are in tolerance Replaced filters Furnace flu pipe that was disconnected was reconnected before my arrival LRA reading 156.6 read /data plate 152.5 standard reading LRA reading 124.7 read /data plate unknown due to tag fading Reccomended compressor saver kits for both systems to lower system LRA reading Downstairs system left on 78 and upstairs left on off per homeowners request

Quoted a duct reseal and adding insulation for $5,993

Came to job for tune up and homeowner didn't understand why I was there and wanted an HVAC tech out there for his second yearly checkup I told him and explain to him that it was free and we just do it for our memberships but he just didn't understand

Arrived for Main home system and Mini split heating tune up Main home 2 return filters replaced All heating components are in tolerance Mini split filters and coil are clean Both systems have in tolerance heating delta Reccomended IAQ200 UV Reccomended Soft start kit upgrade Added home and budget protection plan on main home system System left on heat at exit

System one 2012 carrier heat pump checked all components changed filter observed biological growth in air handler customer will purchase their own uv light and install themselves out door unit has electrical voltage bleeding through wire with main panel breaker off. System two 2012 carrier heat pump checked all components changed filter biological growth present secondary drain pan severly corroded can feel rust getting through to bottom of drain pan dual run capacitor is low 21 out of 45 UF customer will use home Warranty for repairs.

11/30/24 TS- adjusted toilet flapper unit and issue stopped. Was crooked and small leak I to bowl. Stopped once straighten

For this heating tune-up I inspected the upstairs and downstairs furnaces. Both furnaces went through the sequence of operations like they should and ran with no issues. I recommended to the customer a whole home surgeh protection as well as an IAQ 200 UV system for better air quality.

09/24/24 TS- no issues, waterheater is new.

One legger

The home owner and decision maker is out of the country. Quoted a level 1 60k straight cool horizontal for $11495 including code kit. Also quoted a level 2 60k heat pump horizontal for $15067 including code kit. Left the quote with her roommate and also emailed the homeowner the quotes

Today we were scheduled for a cooling tune-up on both their upstairs and downstairs units both units were overamping upon startup customer agreed to adding a compressor saver kit to each unit These units will help extend the life of both compressors by lowering the amount of amp draw upon start up also the dual run capacitor 45 5 for the upstairs unit was out of range swapped it out under P&L warranty homeowner expressed a desire to speak with a comfort advisor about a generac unit Rob set the appointment for Thursday between 10:00 and 12:00

Arrived fit rec work Replaced Evap coil Passed pressure and decay tests Refilled refrigerant System cooling with a 23 super heat at exit

Arrived for eval Customer stated system hasn’t been cooling slowly. Ran test and found leak at the schrader at the unit. Relayed information to customer and replaced scheader and pumped up with refrigerant System running before I left.

2.5 ton gas 2016 condenser, 2 ton duel fuel hp gas. Homeowners utilize home warranty the best they can. Unfortunately both systems are Frankensteins. Goodman furnace, Carrier evaporator coil, Kenmore condenser. Rheem 1996 furnace, carrier evaporator coil, Grand Aire condenser. Filter box in compromised with the edges exposing attic air after filter. Leaks in ductwork and cabin on indoor unit. Both supply plenums have ducting on the ends which steals energy from other rooms and reduces efficiency. 1996 Rheem furnace has a compromised heat exchanger. Shared video and photo evidence to Homeowner. Shared infrared pictures of compromised duct work with Homeowners. Discussed an attic tent. Blower is extremely dirty. Failing capacitor on blower. Homeowner agrees it's dangerous to run. Homeowner is an engineer and is a different Atherton but admitted when it comes to the issues found he relies on professionals. He agreed to a CA visit on Monday 6/24 @6p, to discuss duct and plenum redes

Arrive for Eval Evap coil leaking Ordering new coil

Daniel S. completed annual heat and air conditioning tuneup.

For the super tune-up I inspected three furnaces and all three condensers, all equipment was measuring within manufacturer specs and running well.

Arrived for STu All component were working and in tolerance Recommend IAQ 1000, 200, coil clean, anti microbial mist, compressor saver and surge protector. Membership upgrade System working before we left

During inspection discovered that cap was below tolerance and also that system was low on refrigerant Discovered a small leak from the Schrader valve and tightened it up and was no longer getting a leak anymore and went ahead and also swapped out the cap all under P&L Left customer know if he feels it's not cooling again to call us back out to do a full system leak check Unable to do full system leak check due to severe storm at time of inspection

Tech arrived at a warranty tuneup. Upon inspection, the capacitor was within specs. The contactor was in working condition. The condenser coils were hosed off to assist with air flow across the coils. The filter was dirty and replaced. The drain was flowing slowly. The blower area and ductwork was dirty. The customer was informed of recommendations today. She decided to move forward with upgrading to an AprilAire filter and adding a treatment strip to help keep the drain system clear. These items were installed and functional. She just had a plumber out to unclog the sink. She will contact him if it backs up again. The system was functioning upon departure.