HVAC, Plumbing, & Electrical Services in Argyle, TX

Found blower motor ECM going out when unit would start up floor was not at full capacity and making noise left customer with estimates for new blower motor and protection plans customer wants to have CA come out and give her estimate on new equipment for downstairs downstairs equipment is 4 ton heat pump system electric horizontal

Came to Sue's house for lights going down driveway soon as you enter the gate and half of the lights were out but it was all just because of a GFCI so got her sister to go out on there with me and look at it so that she knows or next time so that they don't have to call us that they could just do it

On this job I looked at heating cool. I stepped up fan speed. Installed easy start New contactor New cap System is cleaned TD is 20 Super heat 15 Subcool 10

For this call I performed an evaluation. System was functioning within normal spec limits at the time of arrival. No abnormalities were noted during inspection. Spoke to homeowner about up sizing one of the ducts for the master bedroom being the furthest room that does not heat well per owner. Homeowner did not commit to a decision but stated they would consider the option a call back if they decide to move forward

Came out to job to swap out low voltage transformer for lights and backyard that we have installed a while ago but also looked at life that weren't working in driveway that we also installed but found a cord that wasn't plugged in at all controlling a light in the driveway mix of lights

Came out to house to look at switches Nate put in that weren't coming on at the right time and also look at lights that Mark installed a few years ago that weren't coming on found a bad transformer and we have ordered one and once it comes in we will come back and replace it which will be next Wednesday

Air quality estimate Quoted 3 options for scenting system Homeowner will call us when he decides

Came to job for smoke detectors chirping and talk to customer about replacing smoke detectors in house and customer agreed so replaced a few smoke detectors and talk to customer and let them know that we're covered for a year warranty and if anything happens in a year call us and we will come back and replace them for free

Came out to house for electrical inspection we have done tons of work here panel has surge protection and everything in house looks great last time I was here with Nate we talked to customer about lighting in the backyard that was damaged and just needed to be replaced to get them all working when I got here customer also said he was having issues with lights at front of gate and they were not coming on when they were supposed to or even at all so so went and looked at it and ended up being to GFCIs that were tripped that were feeding the timers that controlled the lights everything is working explained it to customer and what to do next time if that happens but explained that they can call us anytime they want

Came to house for electrical inspection House is 8 years old and looks great has all the grounds possible in a house everything's working and looks great but customer had eaten combination breakers that were going to go out at some point and one was causing her an issue so talk to her about that and explain to her that she could get them for free and we could just come out and replace them once she gets them

Maintenance performed today on a 7500 watt generac generator installed in 2022. Faulty battery was preventing the generator from starting. Replaced battery and system fired up. Changed oil, filters and spark plug. System operating accordingly upon departure.

Replace main house unit with 60k hz hp with high efficiency filtration, uv system with oxidation and code kit

Pausing call, installed txv and replacement x 13 fan motor. Fan motor will not push correct cfm. Comfort advisor visit set for 10-12 tomorrow.

Came out for an evaluation on an 11-year-old unit the system was freezing due to a restricted TXV unable to guarantee lead time on the TXV so the customer wants to talk to the parts department first before making a decision to replace the TXV or sit down with a comfort advisor

This estimate was for a new build no existing equipment at all he's wanting a complete system install with construction for less than 10

8/6/25 Called and spoke to customer is not a call back needs new disposer. Gave customer eta about an hour in a 1/2 from current job. She said was fine if I came by tomorrow anytime

Replaced delta shower valve cartridge in upstairs bathroom. Also unjammed disposer in kitchen. Tested after repairs were made everything working properly.

Replaced doa condenser. Pulled vacc down to 193 microns and adjusted refrigerant levels to an 8 subcool. System producing 20 degree delta as I left Per Robert- No refrigerant charge Thank you for Choosing Comfort Experts- Have a great Day

7/29/25 On arrival condenser fan motor was running but pulling a large amp draw. Txv metering device was restricted and my leak detector did pick up refrigerant around the back side of coil. Customer opted to replace fan motor and add a compressor saver kit to help compressor start easier. Pausing call, will return once fan motor comes in.

Condenser Board was giving P0 code, Compressor went into thermal, washed the compressor down to cool When compressor started again it gave a loud sound as if it was breaking internally Automatically went into thermal again Diagnosis- Bad compressor Needs new compressor

House was not cooling,charged it up with refrigerant hopefully that was the case. If problem persist, please call back so we can look deeper into the problem Thank you for choosing comfort experts, Have a great day!

For this evaluation the customer's system was throwing an L1, Low Pressure Cutoff fault. When I gauged up and the system was in second stage cooling the system had a 16⁰ superheat and a 10⁰ Subcool indicating the system was appropriately charged. Amp draws on the compressor were within range and the filter and condenser were clean. The furnace was also throwing a fault code saying that the blower motor was operating outside of limits. Ductwork looked good with no kinks, and there was nothing obstructing the evaporater coil. As a precaution I went ahead and leak searched the evaporator coil however I was not getting any hits indicating the coil was leaking. Unfortunately during my testing I was unable to replicate what may have caused the low pressure fault. I updated the furnace as it was due for a software update as well.

Today we showed up for a free plumbing evaluation, we did work back in November of 2024 on the main water line between where the irrigation connects at. Upon arrival the boxes were filled with water, we pumped out the water that was inside the meter box and the meter was not spinning. We open the valve back to the irrigation system and the meter still was not spinning, we had to be homeowner run the irrigation system to find out a sprinkler head is leaking down into the box. He will need to contact irrigation company for that. Thank you for choosing comfort experts!

Pricing on this estimate is to clear the branch arm on the guest restroom on the first floor. The toilet would not flush without backing up, and when flushed would back up into the shower. Comfort Experts will access the backed up line through the toilet. We will put the sewer machine down the line to break up the stoppage. Once the stoppage has been broken up and flushed out, we will test the fixtures affected to ensure proper functioning and that no further Stoppages occur.