Sanger TX

System is at factory specs filter was dirty condenser was cleaned

Came out for an evaluation found a blown fuse in the indoor unit due to a fried UV system remove the UV system and replaced the fuse everything is running as it should

07/08/24 TS- waterheater was not working when I arrived. And did a quick dionostic on the waterheater to see the issue. Because of the age and issue with flame valve, I suggest replacing the unit. Customer agreed upon replacing unit tomorrow once the purchase a new customer supplied waterheater.. Schedule tomorrow 07/08/24 Tuesday for installing new unit

Replaced a warranty hard start for a 4 ton and a dual run 45/5 cap 4 ton hard start and 45/5 dual run cap

Arrived fit CTU filter fine Drains clear System functioning fine with no issues Recommend electrostatic/ polarized filter and UV upgrade with a full system clean Panel surge protection recommended as well

Tech arrived at rec work. The AprilAire filter upgrade kit and filter was installed today. The IAQ 200 UVC System and Air Cleaner was installed, tested and functional. A treatment strip was added to help keep the drain system clean. The system was functioning upon departure.

Tech arrived at a warranty tuneup. Upon inspection, the capacitor was within specs. The contactor was in working condition. The Delta was within range. The filter was dirty and allowed unfiltered air to enter the system. The blower area and ductwork was dirty. The drain was clear and bleach was poured. The customer was informed of recommendations today. She decided to move forward with adding an UVC System and Air Cleaner and an AprilAire filter upgrade kit to the system. The customer would like for this to be performed next week, any day except for Wednesday. The system was functioning upon departure.

03/15/24 Tyler S- waterheater bottom has blown out and gas smell is from the tank not being fully closed. Shows s8gns of rot around flame casing. New waterheater would need a new shut off valve, expansion tank, and gas drip line 50gal natural gas waterheater

2013 5 ton American Standard 410a HP. Drain line clear. Filter replaced. Blower wheel/ motor inspected. Evaporator coil inspected. Amps and volts inspected. Electrical tightned. UV bulb replaced. Condenser fan 10mfd capacitor replaced. Refrigerant levels acceptable. System is in healthy condition.

On this job I inspected the heating side of of the system. The heat pump and back up heat strips are within tolerance. The filter is clean as well. I would recommend ducts to be cleaned

On arrival the system was running and cooling, I checked to ensure there were no issues and found everything working as intended.

Tech arrived at a tune-up. Upon inspection the capacitor was within specs. The contactor was scorched and pitted. The defrost control board had hot spots. The condenser coils were hosed off to assist with air flow across the coils. The delta was within range. The filter was recently replaced. The drain was clear and bleach was poured. The heat strips were functioning. There was growth in the air handler. The blower wheel was dirty. The customer was informed of recommendations today. He decided to move forward with replacing the contactor. This item was replaced, tested and functional. The customer also decided to add a Copper Membership to take advantage of the discounts. The system was functioning upon departure.

Tech arrived at a warranty tuneup. Upon inspection, the capacitor was within specs. The contactor was in working condition. The surge protector was functioning. The filter was replaced. The heating system reached complete ignition. There was visible buildup in the drain line. The drain was clear and bleach was poured. The UV bulb was not working. The customer was informed of recommendations today. She decided to move forward with replacing the current UV bulb and adding a treatment strip to help keep the drain system clean. She will revisit upgrading the UV system next year. The system was functioning upon departure.

Gas propane waterheater needs to add 18" riser and water lines with valve

The ducts supplying the customers master bed room are 2 7" ducts tied into a 50' run of 12" explained to customer that over that lengthy of a duct run the air supplied will lose some velocity and gain a few degrees in temperature informed her the best solution would be to upsize the duct that feeds the two supplies in the master bedroom and to upsize them as well Customer did not want to do that at this time Also fully opened a halfway closed vent in master bedroom

Tech arrived at a warranty service call. Upon inspection, the main breaker was tripped. The compressor saver failed and was replaced. The breaker was repositioned and the outside system came on for a few seconds and the breaker tripped again. The compressor was tested and failed the Ohms test. The guages indicated that there is refrigerant present in the system. We will pause the call to order a compressor.

Upon arrival for service system on and cooling. Inspected system. Electrical conections good. Refrigerant pressures within ranges. Outdoor unit has heavy dust buildup lowering cooling efficiency. Attempted to clean unit. Only spigot on home not functioning. Informed customer and recommended cleaning and a compressor saver kit. System due to inefficiencies in home and system is not able to keep up with extreme temperatures outside. Left system on and cooling.

Upon arrival for service system was on but not cooling. Inspected system and found capacitor out. Replaced capacitor under warranty. Left system on and cooling.