AC Repair & Installation In Azle, TX

Sold level 3 36k heat pump closet upflow with April air filtration for free ( monthly special continued per Rob Goldate)

Installer borrowed a tool from the customer. Ended up losing said tool. I have compensated the customer for the lost tool.

11/26/24 During evaluation of furnace I kept smelling gas, opened furnace up to inspect heat exchanger, located what seems to be a potential failure in the heat exchanger which is unsafe. This can cause carbon monoxide to enter the airstream. Inducer motor flue had lots of build up, system would run for 15 mins and then shut off on role out. Tested airstream for carbon monoxide and was getting extremely high readings. Today I shut the Gas valve of to the furnace due to unsafe operating conditions. Need to return with Brian H to further evaluate furnace

Arrived onsite customer had a water heater in hall closet dripping from tmp. Went ahead and flushed water heater replaced tmp valve and piped the drain pan drain. Tested after repairs were Made everything working properly.

I will call this customer on the 10th to discuss the estimate being made and to find the best solution to his current issues There is a 30 amp breaker with 12 wire that goes to the dish washer and shop The sub panel needs ground and neutrals separate He would like a European plug for his surround sound A GFCI out side won't resent

Complimentary Electrical inspection for Monday 11/25/24 in the afternoon please. 1998 3t r22 electric closet upflow. Completed complimentary inspection for energy efficiency, saftey and reliability. Unit is poorly installed, access to components are against code. Filter system is poor and 1 inch filter is not changed out properly. Evaporator coils have extreme build up, rust, leaks, oil spots and freezes. Blower motor has oil spots present. Blower wheel has extreme buildup. Failing Blower capacitor Only 1 electric heatsrtip functions and that one has very low amps indicating high resistance. Compressor inrush amps exceed manufacturers specifications. Compressor capacitor and fan capacitor are below tolerance. Contactor has heavy scorching and pitting. R22 refrigerant levels are dangerously low. Homeowner was with me for the duration of my visit and i took the time to share evidence, educate and discuss system performance. Homeowner is aware of the all major systems issue

His panel is on the older side but is in great condition no surge protector but connections are tight and recepticals are wired correctly

Gave estimates for new water heater. Customer is interested in financing. Could not get husband on the phone she will discuss options tonite and get back with us tomorrow

Performed free water heater flush. Heater located in closet in laundry room. Gave estimates for code upgrades

Install 2 new 8" supply registers, adding 1 new 8" duct and 1 new 6" register

Tech Cody arrived to customer's home and met the homeowners. Both systems are 12yo comfort Maker heat pumps. LEFT SIDE: INDOOR: systems had a temperature split of 9 degrees, I found a leak in the evaporator coil. The coil had a heavy amount of corrosion on it. I brought the customers to the unit and shared with them what I found. The blower was clean and blower motor was in good condition. The heat strips were functioning within range. No drain protection was installed. OUTDOOR: The refrigerant charge was critically low. The compressor and fan motor were operating within manufacturer range electrically. The capacitor was out of tolerance reading 37 out of 45. I did not recommend replacing it without repairing leak first. Primary electrical control was in good condition. RIGHT SIDE: INDOOR: System had a temperature split of 21 degrees, this coil also have very heavy corrosion but no leak was found. The blower was clean and the blower motor was in good condition. Heat strips were in

2012 3t hp closet downflow. Expired manufacturers warranty. Filter is not replaced regularly. Heat relay has melted wiring. Blower capacitor is out of tolerance. Blower wheel bearings compromised. Blower wheel has heavy build up. Evaporator coil has heavy rust and refrigerant leaks detected. Compressor inrush amps exceed manufacturers LRA. Condenser fan motor capacitor failing. Primary electrical control contractor has heavy scorching and pitting, noisey. Reversing valve coil has a heavy chatter when system is power down. After bring all of my video/photo evidences to elderly Homeowner, she had me speak to her nephew. He was not very pleasant, however he told me that the home would be demolished soon and if there is any hvac emergency that he would send his guys out. Homeowner apologized for her nephews choice words and claimed that she really enjoyed our visit. Dryer vent was falling off - fixed. Declined work per homeowner nephew.

Etu. Multiple issues. Recommended bubble covers and gfci protection in kitchen. No go at this time.n

2020 Amana airhandler Checked and tightened all electrical connections Changed Customer provided filter Drain had slight build up at trap Heat strips were functional and within manufacture range Blower motor and wheel were acceptable Blower wires have biological growth build up Evaporator coil was acceptable 2020 Amana Heatpump Checked and tightened all electrical connections Dual run capacitor was within manufacture range Primary electrical unit was acceptable Refrigerant levels were acceptable at this time Fan blades and motor were acceptable Condenser coil was acceptable Washed Condenser coil from inside out Cleared debris out of unit Waxed top of unit Recommended pan treatment for drain and uv system ti stop biological growth

2017 Coleman airhandler Checked and tightened all electrical connections Changed Customer provided filter Drain was clear and draining Heat strips were functional and within manufacture range Blower motor and wheel were acceptable Blower wires have biological growth build up Evaporator coil has some biological growth build up 2017 Coleman straight electric Checked and tightened all electrical connections Dual run capacitor was within manufacture range Primary electrical unit was acceptable Refrigerant levels were acceptable at this time Fan blades and motor were acceptable Condenser coil was acceptable Washed Condenser coil from inside out Cleared debris out of unit Waxed top of unit Recommended pan treatment and uv 200 or uv 300

Replaced smoke carbon.

Tune up completed,during inspection of air handler I found the blower motor had minor dust build up But the evaporator coil was caked in biological growth, also found the drain was clogged causing system to back up and get return air plenum wet causing more biological growth. Recommended installation of uv 200 as well as clearing drain line and cleaning evaporator coil Cst declined repairs at this time

Came to customers for membership visit and checked everything and gave quote for surge protector

Tune up completed, during inspection I located biological growth build up in supply plenum. Recommend performing cleaning and installing iaq 200 Cst wants to wait on repairs at this time

Tech Cody arrived to customer's home and met the homeowner. System is an 8yo Coleman heat pump. I replaced both filters, the system had a temperature split of 22 degrees. The coil had minimal dust buildup and the blower wheel had dust and biological growth buildup. The blower motor was in good condition and the heat strips were functioning within range. I washed the outdoor coil before taking any readings. The compressor and fan motor were operating within manufacturer range, the auxiliary motor starter was within tolerance and the primary electrical control was in good condition. The refrigerant charge was at acceptable levels at this time. I shared my findings with the homeowner and recommended they swap out their filters at least every 2 months and I also recommended a level two duct cleaning for the home. System was cooling when I left.